Onboard Headers And Connectors - ASROCK Z77M Quick Installation Manual

2.11 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors
(SATA2_2: see p.2, No. 10)
(SATA2_3: see p.2, No. 11)
(SATA2_4: see p.2, No. 12)
(SATA2_5: see p.2, No. 13)
Serial ATA3 Connectors
(SATA3_0: see p.2, No. 9)
(SATA3_1: see p.2, No. 8)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2, No. 19)
(9-pin USB8_9)
(see p.2, No. 21)
28
These four Serial ATA2 (SATA2)
connectors support SATA data
cables for internal storage
devices. The current SATA2
interface allows up to 3.0 Gb/s
data transfer rate.
These two Serial ATA3 (SATA3)
connectors support SATA data
SATA3_1 SATA3_0
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATA2 / SATA3 hard
disk or the SATA2 / SATA3
connector on this motherboard.
Besides six default USB 2.0
ports on the I/O panel, there are
two USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB 2.0
ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
ASRock Z77M Motherboard