Asus P5QPL-VM EPU User Manual page 35

3. IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 100/66 signal cable. There are three
connectors on each Ultra DMA 100/66 signal cable: blue, black, and gray. Connect the
blue connector to the motherboard's IDE connector, then select one of the following
modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the
same setting.
ASUS P5QPL-VM EPU
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode of device(s) Cable connector
—
Master
Slave
Master
Slave
Black
Black
Gray
Black or gray
1-25