Table of Contents
Advertisement
Appendix A – Regulatory Compliance
FCC Part 68 Telecom
1. This equipment complies with part 68 of the Federal Communications Commission Rules. On the outside
surface of this equipment is a label that contains, among other information, the FCC registration number.
This information must be provided to the telephone company.
2. The suitable USOC jack (Universal Service Order Code connecting arrangement) for this equipment is
shown below. If applicable, the facility interface codes (FIC) and service order codes (SOC) are shown.
3. An FCC‐compliant telephone cord and modular plug is provided with this equipment. This equipment is
designed to be connected to the telephone network or premises wiring using a compatible modular jack
that is Part 68 compliant. See installation instructions for details.
4. The ringer equivalence number (REN) is used to determine the number of devices that may be connected
to the telephone line. Excessive RENs on the telephone line may result in the device not ringing in
response to an incoming call. In most, but not all, areas the sum of the RENs should not exceed 5.0. To be
certain of the number of devices that may be connected to the line, as determined by the total RENs,
contact the local telephone company.
5. If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. But if advance notice is not practical,
the telephone company will notify you as soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
6. The telephone company may make changes in its facilities, equipment, operations, or procedures that
could affect the operation of the equipment. If this happens, the telephone company will provide advance
notice in order for you to make necessary modifications in order to maintain uninterrupted service.
7. If trouble is experienced with this equipment (the model of which is indicated below) please contact
Multi‐Tech Systems, Inc. at the address shown below for details of how to have repairs made. If the
trouble is causing harm to the telephone network, the telephone company may request you remove the
equipment from the network until the problem is resolved.
8. No repairs are to be made by you. Repairs are to be made only by Multi‐Tech Systems or its licensees.
Unauthorized repairs void registration and warranty.
9. This equipment should not be used on party lines or coin lines.
10. If so required, this equipment is hearing aid compatible.
11. This product is labeled with the following information:
Manufacturer:
Trade Name:
Model Number:
FCC Registration Number:
Ren:
Modular Jack (USOC):
Service Center in USA:
Multi‐Tech Systems, Inc. MT9234ZBA‐USB User Guide (S000473A)
MultiTech Systems, Inc.
®
MultiModem
ZBA
MT9234ZBA‐USB
US:AU7MM01BMT9234SMI
0.1B
RJ11
Multi‐Tech Systems, Inc.
2205 Woodale Drive
Mounds View, MN 55112
(763) 785‐3500 Fax (763) 785‐9874
Appendix A – Regulatory Compliance
25
Advertisement
Table of Contents
