Installing This Product; Installation Notes; Parts Supplied - Pioneer SPH-DA02 Operation Manual

Section
Installation
03

Installing this product

Installation notes

! Do not install this product in places subject
to high temperatures or humidity, such as:
— Places close to a heater, vent or air con-
ditioner.
— Places exposed to direct sunlight, such
as on top of the dashboard.
— Places that may be exposed to rain,
such as close to the door or on the vehi-
cle's floor.
! Install this product in an area strong en-
ough to bear its weight. Choose a position
where this product can be firmly installed,
and install it securely. If this product is not
securely installed, the current location of
the vehicle cannot be displayed correctly.
! Install this product horizontally on a sur-
face within 0 to 60 degrees tolerance. Im-
proper installation of the unit with the
surface tilted more than these tolerances
increases the potential for errors in the ve-
hicle's location display, and might other-
wise cause reduced display performance.
60°
14
En
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel
and wrap any loose cables so they are not
blocking the vents.
Leave ample
5 cm
space
5 cm

Parts supplied

The display unit
Flush surface screw
(5 mm × 7 mm)
(8 pcs.)
Truss head screw
(5 mm × 6 mm)
(8 pcs.)