Sony RDP-XA700iP Operating Instructions Manual page 37


Setup device:
Method: WPS
Before Starting
1
Place this unit close to the wireless LAN
router/access point.
2
Turn this unit on.
The LINK indicator (page 5) starts to flash
green.
3
Wait for about 70 seconds until the LINK
indicator turns off.
 Note
While it is connected to a Wi-Fi Network, do not turn
this unit off.

GB
WPS
compatible Wireless LAN router/access point
Push-Button
1
2
3
Configuration Method
Starting Network Settings
Press and hold the WPS button on this
unit until the beep sound is output from
this unit.
Press and hold the WPS button on the
router/access point within 90 seconds
after step1.
* The position and shape of the WPS button differ
depending on the model of the router/access point.
 Tip
For details on the WPS button, refer to the operating
instructions of the router/access point.
Check the status of the LINK indicator
(page 5).
When the LINK indicator lights up green,
the connection is established.
Rear of this unit