Indicator Illumination - Panasonic DMP-BBT01 Operating Instructions Manual

Indicator illumination

Reference
Confirm the following items in correspondence to the status of the LED of the unit.
An error condition exists when the Status LED is red. Open the panel at the side of the main unit and
check the status of the indicator LEDs. If the red LED does not turn off even when following operation is
performed, contact your dealer.
Indicator LEDs
Red flashes for 6 times
The red or green light flashes slowly.
Red lights up
Red lights up
38
VQT3W24
The remote control and main unit are using
different codes. Remote control code may be
changed when the battery is changed. Reset the
settings of the main unit and the remote control to
the states at the time of purchase with following
operation.
1 Turn the unit off once, and then turn it on
2 Touch and hold [<] on the main unit for more
3 Press and hold [OPTION] and the green
Remote control code for the main unit and the
remote control will be set to "1". Change the
settings as necessary. (
The unit is carrying out an internal process. This is
not a malfunction. You cannot operate the unit
while the light is flashing. Wait for a while.
The unit fails to operate properly. Touch and hold
Lights up
[Í/I] on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
Flashes
The USB device is drawing too much power.
Lights up
Please disconnect or remove the USB device from
the unit.
The USB device may be incompatible.
Flashes
Description
again.
than 4 seconds while the HOME menu is
displayed.
button at the same time for more than
5 seconds.
37, "Remote Control")