Projector Setup Menu; Status; Projector Id; Initial Start Up - Panasonic PT-FX400U Operating Instructions Manual

PROJECTOR SETUP menu

Select [PROJECTOR SETUP] from the Main
Menu (see "Navigating through the menu" on
page 35), then select the item from the sub-
menu.
After selecting the item, press ◄► to set.
z
Remote Control

STATUS

Displays the status of the projector.
1 ) Press ▲▼ to select [STATUS].
2 ) Press the <ENTER> button.
The [STATUS] screen appears.
z
SIGNAL NAME
SIGNAL
FREQUENCY
PROJECTOR
RUNTIME
LAMP
SERIAL
NUMBER
56
- ENGLISH
Control Panel
Displays the input signal name.
Displays the frequency of the
input signal.
Displays the projector runtime.
Indicates the number of hours
the lamp has been used
Displays the serial number of the
projector.

PROJECTOR ID

The projector has an ID number setting function that
helps the user to control two or more projectors either
simultaneously or separately with a single remote
control.
1 ) Press ▲▼ to select [PROJECTOR ID].
2 ) Press the <ENTER> button.
The [PROJECTOR ID] screen appears.
z
3 ) Press ▲▼ to select [PROJECTOR ID].
Select [ALL] or a number between [1] and [6]
z
from the list that appears.
ALL
6
4 ) Press the <ENTER> button to confirm
the entry.
The selected [PROJECTOR ID] appears.
z
Note
If the projectors are given ID numbers, their remote
z
controls must be assigned the same ID numbers,
respectively.
If the ID number of a projector is set to [ALL], it can be
z
controlled by the remote control or the PC with any ID
number.
If multiple projectors are used and some of them
have their IDs set to [ALL], they cannot be controlled
separately from the projectors with other ID numbers.
For details on remote control ID setting, refer to "Setting
Remote control ID numbers" (

INITIAL START UP

Use the steps below to select INITIAL START UP
when the projector is connected to a wall outlet.
1 ) Press ▲▼ to select [INITIAL START
UP].
2 ) Use ◄► to switch [INITIAL START UP]
settings.
Each press of the button switches the settings
z
as shown below.
LAST MEMORY STANDBY
LAST
Starts up the projector in the mode it
MEMORY was in when last shut down
STANDBY Starts up in standby mode
ON Starts projection immediately
1
2
Æ
page 20).
ON