Power On/Off - Hitachi CP-A222WN User Manual

Power on/off

Turning on the power
Make sure that the power cord is firmly
1.
and correctly connected to the projector
and the outlet.
Make sure that the POWER indicator is
2.
steady orange (
Confirm that there is nothing that the lens
3.
door hits while opening. Press STANDBY/
ON button on the projector or the
remote control. The lens door opens, the
projection lamp lights up, and the POWER
indicator begins to blink green. When the
power is completely on, the indicator will
stop blinking and light in steady green
119).
(
To display the picture, select an input signal according to the section Selecting an
input signal (
The INITIAL SETTING Menu will be displayed by factory default upon startup.
Once the INITIAL SETTING Menu is set, it will not appear until FACTORY RESET
69) is executed. If you wish to change the settings, refer to the LANGUAGE
(
52) and ALTITUDE (
(
(1) LANGUAGE: Use the ▲/▼/◄/►
buttons to select the desired language
and press the ENTER button of the
remote control or the INPUT button of
the projector to execute.
(2) ALTITUDE: Use the ▲/▼ buttons to
select NORMAL for altitude below
1600 m (5250 feet), otherwise select
HIGH and press the ENTER button of
the remote control or the INPUT button
of the projector to execute.
(continued on next page)
119).
22).
62) menu.
Power on/off
STANDBY/ON button
POWER indicator
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY PAGE VOLUME
FREEZE
ON UP
OFF DOWN
MY BUTTON
KEYSTONE MUTE
FOCUS D-ZOOM
POSITION MENU
ENTER
ESC RESET
19