Panasonic TH-50PF50U Operating Instructions Manual page 50

SETUP for PORTRAIT
4
VIEWING AREA / LOCATION
VIEWING AREA: Set a mode of image division for PORTRAIT function.
LOCATION: Set a location of image to be displayed for PORTRAIT function.
Press to select VIEWING AREA or LOCATION.
Press to select each function.
Notes:
• For HD signal videos, the "VIEWING AREA" is set at "16:9",
• When "VIEWING AREA"is "16:9", the aspect mode is set to "FULL".
LOCATION setting
When PORTRAIT SETUP "ON":
Display the image of the selected LOCATION.
VIEWING AREA and LOCATION
The mode of image division and the LOCATION by setting of VIEWING AREA is as follows.
VIEWING AREA: 16:9
LOCATION 1
Undisplayed area (48 dots)
VIEWING AREA: 4:3
LOCATION 1
5
VIDEO WALL UNIFORMITY
Reduces the peak of brightness for each display to enable as uniform display as possible.
Press to select VIDEO WALL UNIFORMITY.
Press to select "OFF" , "ON".
50
and cannot be changed.
HD signal: 1125 (1080) / 60i • 50i • 60p • 50p • 24p • 25p • 30p
• 24sF, 750 (720) / 60p • 50p, 1250 (1080) / 50i
LOCATION 2
LOCATION 2
The brightness depends on
each display's setting.
OFF
When PORTRAIT SETUP is "OFF":
Represent an area of the selected LOCATION at a normal
brightness and darken the rest of it.
LOCATION 3
LOCATION 3
The brightness difference
is minimized.
ON
PORTRAIT SETUP
PORTRAIT SETUP
SEAM HIDES VIDEO
VIEWING AREA
LOCATION
VIDEO WALL UNIFORMITY
Suitable to display FULL images. NORMAL
(4:3) images extend transversely.
Both right and left sides of the image are
cut by 48 dots.
4:3 images are displayed without changing
aspect ratio.
Although the images of each LOCATION
overlap, you can adjust POS./SIZE to display
the image normally. (see page 26)
PORTRAIT SETUP
PORTRAIT SETUP
SEAM HIDES VIDEO
VIEWING AREA
LOCATION
VIDEO WALL UNIFORMITY
Note:
If you set VIDEO WALL UNIFORMITY to ON,
the following menus will be unavailable and
these settings will be ¿ xed to the initial values.
PICTURE menu: COLOR, TINT, INPUT
LEVEL (ADVANCED
SETTINGS)
OFF
OFF
16:9
1
OFF
OFF
OFF
16:9
1
OFF