Table of Contents
Advertisement
2.13 Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
drive fi rst. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from up to bottom side
to install those required drivers. Therefore, the drivers you install can work properly.
2.14
Installing Windows
/ XP 64-bit Without RAID Functions
If you want to install Windows
bit OS on your SATA / SATAII HDDs without RAID functions, please follow below
procedures according to the OS you install.
2.14.1 Installing Windows
Functions
If you want to install Windows
without RAID functions, please follow below steps.
Using SATA / SATAII HDDs with NCQ function
STEP 1: Set Up UEFI.
A. Enter UEFI SETUP UTILITY
B. Set the option "SATA Mode" to [AHCI].
STEP 2: Make a SATA / SATAII driver diskette. (Please use USB fl oppy or
fl oppy disk.)
A. Insert the Support CD into your optical drive to boot your system.
B. During POST at the beginning of system boot-up, press <F11> key, and then a
window for boot devices selection appears. Please select CD-ROM as the boot
device.
C. When you see the message on the screen, "Do you want to generate Serial
ATA driver diskette [YN]?", press <Y>.
D. Then you will see these messages,
Please insert a diskette into the fl oppy drive.
WARNING! Formatting the fl oppy diskette will
lose ALL data in it!
Start to format and copy fi les [YN]?
Please insert a fl oppy diskette into the fl oppy drive, and press <Y>.
E. The system will start to format the fl oppy diskette and copy SATA / SATAII drivers
into the fl oppy diskette.
7 / 7 64-bit / Vista
®
®
TM
7 / 7 64-bit / Vista
/ Vista
XP / XP 64-bit Without RAID
®
®
XP / XP 64-bit OS on your SATA / SATAII HDDs
Advanced screen
30
TM
TM
/ Vista
64-bit / XP
TM
64-bit / XP / XP 64-
SATA Confi guration.
Advertisement
Table of Contents
