Lithium Battery Caution; Laser Safety Statement; Tv Antenna Connectors Protection - HP VH677UA#ABA - Pavilion Dv6-1244sb Entertainment Support Manual

Lithium Battery Caution

WARNING: The PC uses a lithium battery, type
CR2032. There is danger of an explosion if the
battery is incorrectly replaced. Replace only with
the same, or equivalent, type recommended by
the manufacturer. Dispose of used batteries
according to the manufacturer's instructions.

Laser Safety Statement

Class 1 LED Product
The CD-ROM and DVD-ROM drives contain a laser system
and are classified as a "Class 1 Laser Product" under a
U.S. Department of Health and Human Services (DHHS)
Radiation Performance standard according to the Radiation
Control for Health and Safety Act of 1968.
Should the unit ever require maintenance, contact an
authorized service location.
WARNING: Use of controls, adjustments, or
performance procedures other than those
specified in the Upgrading and Servicing Guide
may result in hazardous radiation exposure.
To prevent direct exposure to laser beam, do
not try to open the enclosure of the CD-ROM
or DVD-ROM.
Laser Product Label
The following label or equivalent is located on the surface of
HP laser products:

TV Antenna Connectors Protection

External Television Antenna Grounding
If an outside antenna or cable system is connected to the
product, be sure the antenna or cable system is electrically
grounded so as to provide some protection against voltage
surges and built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA 70, provides
information with regard to proper electrical grounding of the
mast and supporting structure, grounding of the lead-in wire
to an antenna-discharge unit, size of grounding conductors,
location of antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode.
This label indicates that the
product is classified as a
CLASS 1 LASER PRODUCT.
This label appears on a
laser device installed in
your product.
Lightning Protection
For added protection of any Hewlett-Packard product during
a lightning storm, or when it is left unattended and unused
for long periods of time, unplug the product from the wall
outlet and disconnect the antenna or cable system. This will
prevent damage to the product from lightning and power
line surges.
1
Antenna Grounding
Antenna Grounding
Reference Grounding Component
1 Electric Service Equipment
Power Service Grounding Electrode System
2
(NEC Art 250, Part H)
Ground Clamps
3
Grounding Conductors (NEC Section 810-21)
4
Antenna Discharge Unit (NEC Section 810-20)
5
Ground Clamp
6
Antenna Lead in Wire
7
Power Lines
An outside antenna system should not be located in the
vicinity of overhead power lines or other electric light or
power circuits, or where it can fall into such power lines or
circuits.
WARNING: When installing an outside antenna
system, extreme care should be taken to keep
from touching such power lines or circuits as
contact with them could be fatal.
7
6
5
4
3
2
19