HP Xw6600 - Workstation - 2 GB RAM Installation Manual page 7

Installing the second processor in HP xw series Workstations
After preparing the workstation for component installation, perform the following steps to install the
processor:
1. Remove the processor socket protective cover.
Figure 3
2. If there is a plastic plug in the second processor heatsink hole, remove it.
3. Raise the processor socket handle fully
Figure 4
4. To install the processor:
a. Remove the plastic cover from the processor.
b. Align the notches in the processor base with the tabs on the socket.
ENWW
Removing the socket protective cover
Opening the processor socket
. Open the processor socket cover plate
Step 3—Installing the second processor
.
2
7