Step 1-Preparing For Component Installation; Accessing The Internal Components Of The Computer - HP Xw4600 - Workstation - 2 GB RAM Installation Manual

Step 1—Preparing for component installation
NOTE: Computer models vary. All illustrations are examples only.

Accessing the internal components of the computer

1. If you need help preparing the computer for this installation, consult the removal and
replacement procedures in the service guide for your computer at
manuals.
2. Power down the computer, and then disconnect the power cord.
3. Power down all external devices, and then disconnect them from the computer.
4. Remove the side access panel.
Step 2—Preparing and installing the hard drive
All instructions pertain to installing the hard drive in an internal hard drive bay. For information about
other types of installations, see
Throughout this document, all references to hard drives include solid state drives.
Precautions for handling the drive
●
Do not move the drive during operation.
●
Avoid placing the drive in a location that is subject to extreme temperatures or mechanical
vibration.
●
Keep the original packing materials for future transportation of the drive.
●
If any object or liquid falls into the cabinet, immediately unplug the computer and have it checked
by an authorized service provider.
HP Z200 and Z400 Workstations and HP xw4000 series Workstations
1. If a card support interferes with access to the system board connectors, remove it.
2. Install four guide screws into the holes near the corners on the sides of the hard drive.
●
For HP xw4000 series Workstations, use four 6-32 screws.
●
For HP Z200 and Z400 Workstations, use four vibration isolation guide screws, (screws
with blue grommets).
NOTE:
spare guide screws installed in the sheet metal of the drive bay structure to be used for this
purpose.
ENWW
Before you begin on page
The HP Z200 and Z400 Workstations and HP xw4000 series Workstation chassis have
http://www.hp.com/support/
1.
Step 1—Preparing for component installation 3