Step 1-Preparing The Workstation - HP Xw4400 - Workstation - 2 GB RAM Installation Manual

Cru dataport dx115 kit

Hide thumbs Also See for Xw4400 - Workstation - 2 GB RAM:

Step 1—Preparing the workstation

To prepare the workstation:

Refer to your workstation documentation for instructions on disassembling and preparing the

workstation for installation. Follow the instructions for shutting down power and disconnecting all

power from the system.

Remove the access panel and front bezel of your workstation. If necessary, refer to the Service

and Technical Reference Guide for your HP Workstation at

workstation_manuals.

Step 2—Installing the DX115 case into the optical drive bay

Refer to the steps for your workstation in the following sections.

CAUTION:

Other procedures may result in system hangs, data loss or even drive damage. (The component

supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the

workstation is booted and then powering the drive via the enclosure's power switch. Microsoft Windows

XP and Vista do not support this action.)

HP xw6000 Workstation series

Remove and discard the counter-sunk screw at the side of the DX115 case as shown (for xw6000

series only). This hole will be used for the shipping screw.

Install the DX115 unit in the optical drive bay using the quick release system.

CRU Dataport DX115 kit installation

Insert or remove the carrier (with a disk drive) only when the workstation is shut down.

http://www.hp.com/support/

ENWW

Table of Contents