Toshiba Satellite L305D-S5974 Resource Manual page 44

44
Using the optical drive
5 Hold the disc by its edges and check that it is free of dust.
If the disc is dusty, clean it.
6 Place the disc carefully in the disc tray, label side up.
(Sample Illustration) Positioning the disc in the drive
7 Gently press the disc onto the center spindle until it clicks into
place.
8 Make sure the disc is completely on the spindle and is lying flat
on the tray.
9 Push the disc tray in by pressing gently on the center of the tray
until it clicks into place.
You are ready to use the disc.
Removing a disc with the computer on
To remove an optical disc with the computer turned on:
1 Press the eject button on the drive.
2 Pull the tray out until it is fully open, remove the disc, and
place it in its protective cover.
Handle DVDs and CDs carefully, making contact only with the center
hole and edge. Do not touch the surface of the disc. Do not stack
discs. If you incorrectly handle the discs, you could lose data.
If you insert the disc incorrectly, it may jam the drive. If this happens,
contact Toshiba support for assistance.
Do not press the eject button while the drive in-use indicator light is
glowing. Doing so could damage the disc or the drive.
Also, if the disc is still spinning when you open the disc tray, wait for
it to stop spinning before you remove it.