Table of Contents
Advertisement
Satellite U500/U500D, Satellite Pro U500/U500D
Installing a memory module
Follow the steps below to install a memory module.
1. Set the computer to boot mode and turn off the power.
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Chapter 6,
4. Loosen the screws securing the memory module cover.
5. Slide your fingernail or a thin object under the cover and lift it off.
6. Lift one side of the insulator sheet and fit the module's connectors into
the computer's connectors at about a 45 degree angle. Press the
module carefully to ensure a firm connection.
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
Slot A is reserved for main memory. Slot B is for expanded memory. If only
one memory module is installed, use Slot A. Slot A is lower than slot B.
8-8
Power and Power-Up
Hard Disk and Memory Module Cover
Figure 8-5 Removing the memory module cover
Modes).
User's Manual
Advertisement
Table of Contents
