Replacing An Adapter - Lenovo IdeaCentre K210 Hardware Replacement Manual

4. Position the new memory module over the memory connector. Make sure
the notch
system board. Push the memory module straight down into the connector
until the retaining clips close.
5. Refer to the "Completing the installation".

Replacing an adapter

Attention
Do not remove the computer cover or attempt any repair before reading the
"Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at http://www.lenovo.com/support.
To replace an adapter:
1. Remove the computer cover. Refer to "Removing the computer cover".
31032753 IdeaCentre K_HRG_EN.indd 17
on the memory aligns correctly with the connector key on the
Hardware Replacement Guide
2007.12.10 3:53:23 PM
17