Onboard Headers And Connectors - ASROCK A75iCafe Quick Installation Manual

2.10 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors
(SATA_1: see p.2, No. 9)
SATA_1
(SATA_2: see p.2, No. 10)
(SATA_3: see p.2, No. 17)
(SATA_4: see p.2, No. 18)
(SATA_5: see p.2, No. 21)
(SATA_6: see p.2, No. 20)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 23)
(9-pin USB8_9)
(see p.2 No. 22)
These six Serial ATA3
(SATA3) connectors support
SATA_2
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
SATA_3 SATA_4
SATA_5 SATA_6
Either end of the SATA data
cable can be connected to the
SATA3 hard disk or the SATA3
connector on this motherboard.
Besides four default USB 2.0
USB_PWR
P-7
ports on the I/O panel, there
P+7
GND
DUMMY
are two USB 2.0 headers on
1
this motherboard. Each USB 2.0
GND
P+6
header can support two USB
P-6
USB_PWR
2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
ASRock A75iCafe Motherboard
27