Onboard Headers And Connectors - ASROCK A55DEL User Manual

2.10 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors
(SATA_1: see p.12, No. 8)
SATA_1
(SATA_2: see p.12, No. 9)
(SATA_3: see p.12, No. 16)
(SATA_4: see p.12, No. 17)
(SATA_5: see p.12, No. 20)
(SATA_6: see p.12, No. 19)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.12 No. 22)
(9-pin USB8_9)
(see p.12 No. 21)
Infrared Module Header
(5-pin IR1)
(see p.12 No. 24)
These six Serial ATA2
(SATA2) connectors support
SATA_2
SATA data cables for internal
storage devices. The current
SATA2 interface allows up to
3.0 Gb/s data transfer rate.
SATA_3 SATA_4
SATA_5 SATA_6
Either end of the SATA data
cable can be connected to the
SATA / SATAII hard disk or the
SATAII connector on this
motherboard.
Besides six default USB 2.0
USB_PWR
P-7
ports on the I/O panel, there
P+7
GND
DUMMY
are two USB 2.0 headers on
1
this motherboard. Each USB 2.0
GND
P+6
header can support two USB
P-6
USB_PWR
2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
This header supports an
IRTX
+5VSB
optional wireless transmitting
DUMMY
and receiving infrared module.
1
GND
IRRX
30