Manual Setup - NETGEAR WPN824N - RangeMax Wireless-N 150 Router Setup Manual

Manual Setup

There are two steps to setting up your wireless router:
1. Connect the Product Family to the ADSL or cable modem, and connect a computer to the
Product Family.
Your computer has to be set to automatically get its TCP/IP network settings from
the Product Family through DHCP. This is usually the case. If your are unsure about
this, use the wizard on the CD, which automatically takes care of this for you, or
refer to the documentation for your computer.
2. Configure the Product Family to use your Internet service.
Connecting Your Wireless Router
To connect your wireless router:
1. Connect the wireless router, the computer, and the modem.
a. Turn off your computer.
Turn off and unplug the cable or ADSL broadband modem.
b.
Locate the Ethernet cable (1) that connects your computer to the modem.
c.
Figure 6
Disconnect the cable at the modem (2). You will connect it to the router later.
d.
Getting to Know Your Wireless Router
RangeMax Wireless-N 150 Router WPN824N Setup Manual
1
2
v1.0, November 2009
8