Asus MEB-VM User Manual page 32

III. HARDWARE SETUP
27. ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT:
on the 5-volt standby lead (+5VSB). You may experience difficulty in powering
on your system if your power supply cannot support the load. For Wake-On-
LAN support, your ATX power supply must supply at least 720mA +5VSB.
MEB-VM ATX Power Connector
32
Make sure that your ATX power supply can supply at least 10mA
ASUS MEB-VM User's Manual
+3.3 Volts +3.3 Volts
+3.3 Volts
-12.0 Volts
Ground
Ground
+5.0 Volts
Power Supply On
Ground
Ground
+5.0 Volts
Ground
Ground
Ground
Power Good
-5.0 Volts
+5V Standby
+5.0 Volts
+12.0 Volts
+5.0 Volts