Asus MEB-M User Manual page 28

III. HARDWARE SETUP
13. Wake-On-Ring Header (2-pin WOR)
These connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that the PWR UP On Modem Act Power Up
Control is set to Enabled (see Power Management Setup under BIOS SETUP) and that
your system has an ATX power supply with at least 720mA +5V standby power.
MEB-M
MEB-M Wake-On-Ring Header
14. IrDA-Compliant infrared module connector (5-pin IR)
This connector supports the optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support this
feature. You must also configure the setting through "UART2 Use Infrared" in
Chipset Features Setup to select whether UART2 is directed for use with COM2
or IrDA. Use the five pins as shown on the Back View and connect a ribbon cable
from the module to the motherboard according to the pin definitions.
MEB-M
MEB-M Infrared Module Connector
28
R
+5V IRRX IRTX
(NC) GND
R
ASUS MEB-M User's Manual
WOR
Pin 1 PIXRI#
Pin 2 Ground
Front View Back View
IRTX
GND
+5V
(NC)
IRRX