ASROCK 960GM-VGS3 FX Quick Installation Manual page 12

LED is on when the system is operating. The LED keeps blinking
when the sys-tem is in S1 sleep state. The LED is off when the system
is in S3/S4 sleep state or powered off (S5).
HDLED (Hard Drive Activity LED):
Connect to the hard drive activity LED on the chassis front panel. The
LED is on when the hard drive is reading or writing data.
The front panel design may differ by chassis. A front panel module
mainly consists of power switch, reset switch, power LED, hard drive
activity LED, speaker and etc. When connecting your chassis front
panel module to this header, make sure the wire assignments and the
pin assign-ments are matched correctly.
Chassis Fan Connector
(4-pin CHA_FAN1)
(see p.2 No. 9)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.2 No. 5)
Though this motherboard provides 4-Pin CPU fan (Quiet Fan) support, the 3-Pin
CPU fan still can work successfully even without the fan speed control function.
If you plan to connect the 3-Pin CPU fan to the CPU fan connector on this
motherboard, please connect it to Pin 1-3.
ATX Power Connector
(24-pin ATXPWR1)
(see p.2 No. 6)
12
ASRock 960GM-VGS3 FX / 960GM-VS3 FX Motherboard
Please connect the fan cable
to the fan connector and
match the black wire to the
ground pin.
Please connect the CPU fan
GND
cable to the connector and
+12V
CPU_FAN_SPEED
match the black wire to the
FAN_SPEED_CONTROL
ground pin.
Pin 1-3 Connected
3-Pin Fan Installation
Please connect an ATX power
12 24
supply to this connector.
1 13