Battery Pack And Power - Sony DSC-W220/B - Cyber-shot Digital Still Camera Handbook

Troubleshooting

Battery pack and power

Cannot insert the battery pack.
Insert the battery pack correctly by pushing the battery eject lever.
•
Cannot turn on the camera.
After inserting the battery pack into the camera, it may take a few moments for the camera to
•
power up.
Insert the battery pack correctly.
•
The battery pack is discharged. Insert a charged battery pack.
•
The battery pack is dead (page 123). Replace it with a new one.
•
Use a recommended battery pack.
•
The power turns off suddenly.
If you do not operate the camera for about three minutes while the power is on, the camera
•
turns off automatically to prevent wearing down the battery pack. Turn on the camera again.
The battery pack is dead (page 123). Replace it with a new one.
•
Depending on the temperature of the camera and the battery pack, the power may turn off
•
automatically to protect the camera. In this case, a message appears on the LCD screen before
the camera turns off.
The remaining charge indicator is incorrect.
This phenomenon occurs when you use the camera in an extremely hot or cold location.
•
A discrepancy arose between the remaining charge indicator and the actual remaining battery
•
charge. Fully discharge the battery pack once, then charge it to correct the indication.
The battery pack is discharged. Insert a charged battery pack.
•
The battery pack is dead (page 123). Replace it with a new one.
•
Cannot charge the battery pack.
You cannot charge the battery pack using the AC Adaptor (sold separately). Use the battery
•
charger to charge the battery.
The CHARGE lamp flashes while charging the battery.
Remove and reinsert the battery pack, making sure it is installed correctly.
•
The temperature may be inappropriate for charging. Try charging the battery pack again
•
within the proper charging temperature range (10°C to 30°C). Refer to page 124 for details.
106