Check Rotating Floor Brush And Drive Belt; Replace Drive Belt - Bissell PowerGlide Platinum Vacuum User Manual

Check Rotating Floor Brush and Drive Belt

You should check your vacuum cleaner's Rotating
Floor Brush and Drive Belt regularly for wear or
damage. You should also clean the brush and brush
ends of string, hair, and carpet fibers. These can
wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any
debris that has accumulated under the brush cover.
Unplug cleaner from electrical outlet.
1.
Place handle in Low position and turn vacuum
2.
cleaner over so bottom side is up.
Remove the four screws as shown with a Phillips
3.
head screwdriver. Lift the Brush Cover off.
Grasp Rotating Floor Brush at both ends and
4.
lift up.
Clean strings, hair and other debris from Rotating
5.
Floor Brush, paying particular attention to
brush ends.
Clean strings, hair and other debris from Motor
6.
Pulley and Drive Belt areas.
Check Drive Belt carefully for wear, cuts or
7.
stressed areas.
Check Air Passageway for obstructions. Remove
8.
debris from this area.

Replace Drive Belt

Use only BISSELL Style 7 Replacement Belts (#32074) in
your BISSELL PowerGlide.
Unplug cleaner from electrical outlet.
1.
With Rotating Floor Brush removed from vacuum
2.
cleaner ( Steps 1-4 above), stretch old Drive Belt
to clear Motor Pulley and remove. Discard old
Drive Belt.
Place new Drive Belt over Motor Pulley and
3.
stretch other end over Rotating Floor Brush.
W A R N I N G :
To reduce the risk of
injury from moving
parts, turn off vacuum
cleaner and discon-
nect Power Plug from
electrical outlet.
Brush
Cover
11