Always there to help you Register your product and get support at www.philips.com/welcome DS3205 Question? Question? Contact Contact Philips Philips User manual...
Contents 1 Important Safety 2 Your Docking Speaker Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on 4 Play Play from iPod/iPhone Play from an external device Adjust volume 5 Product information Specifications 6 Troubleshooting 7 Notice...
1 Important Safety l Unplug this apparatus during lightning storms or when unused for long periods of time. Important Safety Instructions m Refer all servicing to qualified service personnel. Servicing is required when a Read these instructions. the apparatus has been damaged in any way, such as power-supply cord or plug b Keep these instructions.
Page 5
r Where the plug of the Direct Plugin Adapter is used as the disconnect device, the disconnect device shall remain readily operable. Warning • Never remove the casing of this apparatus. • Never lubricate any part of this apparatus. • Never place this apparatus on other electrical equipment.
2 Your Docking Overview of the main unit Speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this docking speaker, you can enjoy audio from your iPod/iPhone or other audio devices.
3 Get started Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No.
Turn on Press to turn the docking speaker on. » The LED indicators light up. Switch to standby mode The docking speaker switches to standby mode in following situations: • Press again; • The speaker is idle for 15 minutes when powered by AC supply.
4 Play Start to play music from your iPod/iPhone. » Music streams from the docking speaker automatically. Charge the iPod/iPhone Play from iPod/iPhone The docked iPod/iPhone begins to charge automatically after connected to AC power. You can enjoy audio from iPod/iPhone through this docking speaker.
2 x 5 W RMS Signal to Noise Ratio 85 dB General information AC/DC switching Model: OH- adapter 1018A1002000U-UL (Philips) Input: 100-240 V~, 50/60 Hz, 650 mA; Output: 10 V Batteries 4 x AA batteries Operation Power 18 W Consumption Standby Power <0.5 W...
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.
Your product is designed and manufactured device that are not expressly approved by with high quality materials and components, Philips Consumer Lifestyle may void the user’s which can be recycled and reused. authority to operate the equipment. Never dispose of your product with other Notice for the USA household waste.
Page 14
“Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless performance.