Optional Manual Configuration / Tv Setup - LG 42CQ610H Commercial Mode Setup Manual

Hospital tvs
Hide thumbs Also See for 42CQ610H:
Table of Contents

Advertisement

Optional Manual Configuration / TV Setup

The manual configuration procedures below should only be performed if you do not know the RF
channels at the site and need to "Learn" an FTG Configuration file from an LQ630H or CQ610H TV as
described on the previous page. Ensure the TV is in Pass-through Mode before you begin.
Set Installer Menu Items
These steps provide specific instruction only on the Installer Menu items
that should be set on an LQ630H or CQ610H TV. Refer to pages 19 to 26
for detailed information on all Installer Menu items.
1. Make sure the TV is ON. Then, use the Installer Remote to enter the
Installer Menu: Press MENU repeatedly until the on-screen display of the
TV setup menus no longer toggles, and then press 9-8-7-6 + OK (Enter).
2. Set Installer Menu item 117 FACT DEFAULT to 001 and press OK
(Enter) on the Installer Remote.
This clears all Installer Menu custom settings, the channel lineup, etc.
and reloads the factory default settings. The value will change back to
0 after the commercial controller (PTC) has been restored to factory
default condition. This step ensures that the TV Channel Memory will be
the active channel lineup.
3. Set Installer Menu item 003 BAND/AFC, as appropriate.
Broadcast: Set to 000.
CATV: Set to 001 (default).
4. Set Installer Menu item 027 HOSPITAL MODE, as appropriate, to select
the speaker configuration.
5. Set any other Installer Menu items that affect your TV programming
network to the required configuration. For example, enable/disable Aux
inputs, set a Start Channel, etc.
6. After you have adjusted all Installer Menu item settings as required,
press OK (Enter) once on the Installer Remote to save your changes;
then, press OK (Enter) again to exit the menu.
Run Auto Tuning (Channel Search)
Note: In the FTG Configuration file, Logical Channel numbers will automati-
cally be assigned in ascending order, starting with 0 (zero), to the Physical
Channels from the TV Channel Map.
Note: Pro:Idiom decryption for encrypted channels will not be enabled unless
you use the FTG File Manager to set the channel attributes.
1. Search for all available analog and digital channels: Use the Installer
Remote to go to the Channel Menu, select the Auto Tuning option, and
follow the on-screen instructions.
2. Use the Channel Edit option in the Channel Menu to edit the channel
lineup, as necessary, to include free to guest channels only. Add/delete
channels per your system requirements.
Once you have completed these procedures, return to "Learning an FTG Configuration
File from a TV" on the previous page to complete the Learn sequence.
206-4207
HRC: Set to 002.
IRC: Set to 003.
FTG Mode via CPU (Cont.)
xxLQ630H PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ
UPN 000-000-000-000
PTC V1.00.013
Typical Installer Menu
Note: The Installer Menu header will vary
depending on the TV you are setting up.
117
FACT DEFAULT
003
BAND/AFC
027
HOSPITAL MODE
Adjust the values for these
Installer Menu items.
CHANNEL
• Auto Tuning
Manual Tuning
Channel Edit
Channel Label
Use Channel Menu options to
run Auto Tuning and edit the
channel lineup, as necessary.
000
ASIC D279
CPU V3.07.00
000
001
254
Move
Enter
47

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

22lq630h26lq630h32lq630h

Table of Contents