LG 32LX4DCS Owner's Manual page 54

Reference
MODE
MODE
COMP/RGB/DVI
FLASHBK
MUTE MUTE
SURF
VOL CH
CH
SAP RATIO
INFO CC
ENTER
MENU EXIT
MENU
SOUND VIDEO
PLAY PAUSE STOP RECORD
REW FF SKIP
54
Programming the Remote Contrtol
G The remote control is a multi-brand or universal remote control. It can be pro-
grammed to operate most remote-controllable devices of other manufacturers.
Note that the remote control may not control all models of other brands.
Programming a code into a remote mode
1. Test your remote control.
To find out whether your remote control can operate the component without pro-
gramming, turn on the component such as a VCR and press the corresponding
MODE button (VCR) on the remote control, while pointing at the component. Test
the POWER and CH +/- buttons to see if the component responds properly. If not,
the remote requires programming to operate the device.
2. Turn on the component to be programmed, then press the corresponding MODE
button on the remote control.
3. Press the MENU and MUTE buttons simultaneously, the remote control is ready to
be programmed for the code.
4. There are two ways to find the right code for the component.
A. If you press the CH +/- buttons repeatedly, the codes will change one at-a-time.
Press the POWER button after each code change. If the right code is found, the
device will turn off.
B. Enter a code number using the number buttons on the remote. Programming
code numbers for the corresponding component can be found on the following
pages. Again, if the code is correct, the device will turn off.
5. Press the MENU button to store the code.
6. Test the remote control functions to see if the component responds properly. If not,
repeat from step 2.