RocketFish RF-HTS205 Quick Setup Manual

7-outlet Power Manager
RF-HTS205
QUICK SETUP GUIDE
Congratulations on your purchase of this Rocketfish Power Manager
with surge protection and noise filtering.
Your power manager:
• Reduces energy consumption to save environmental resources
and lower your electric bill
• Provides surge protection for sensitive electronic devices
• Incorporates noise filtering to provide clean power that will
maximize the performance of your devices
Features
1 Energy Savings (ES) Switch – Turn this switch ON to enable
Energy Savings (the master-controlled outlets are shut down
when the the device plugged into the master outlet is turned off.)
When this switch is OFF all outlets are always-on.
2 One master outlet – controls power to the four
master-controlled outlets.
3 Four master-controlled outlets – When the Energy Savings
Switch is ON, these outlets automatically shut down to conserve
energy when the device plugged into the master outlet is turned
off. When the Energy Savings Switch is OFF, these outlets are
always-on.
4 Two always-on outlets – provide continuous power regardless
of Master/Master-controlled outlets state.
5 Main power switch/circuit breaker – controls power to all AC
outlets on the Power Manager, and allows the unit to be reset in
the event of a circuit overload (after the overload condition has
been resolved).
6 Grounded LED indicator – lights when a properly grounded AC
outlet is detected. If this LED does not light, we recommend that
you contact a certified, licensed electrician to inspect your wiring.
7 Protected LED indicator – lights when the surge protection
feature is working properly. If this LED does not light or goes out,
the surge protection feature has reached full capacity and can no
longer absorb additional surges and spikes. The power manager
should be replaced if this light goes out.
8 5 ft (1.5 m) Soft-Flex™ power cord with right-angle/off-set
plug – enables placement of the Power Manager in the desired
location. The right-angle plug allows you to place furniture as
close as possible to the wall and not block the second AC outlet.