Using The Projector In Standby Mode - ViewSonic PJD5132 User Manual

2. Press to highlight 3D Settings and press MODE/ENTER on the projector or
Enter on the remote control.
3. Press to highlight 3D Sync and press MODE/ENTER on the projector or Enter
on the remote control.
4. Press to select a 3D Sync setting according to the table below and then press
MODE/ENTER on the projector or Enter on the remote control to confirm.
Input signal type (resolution)
HDMI (PC) and DVI-D 120Hz
signals (SVGA 120Hz, XGA 120Hz,
WXGA 120Hz, 1280x720 120Hz)
HDMI (PC) and DVI-D 60Hz signals
(up to 1920x1200 60Hz)
Video, S-Video signals (HQFs) and
Component video, HDMI signals
(NTSC 480i)
Component video, HDMI signals
(480p, 720p, 1080p, 1080i) without
3D information frame
HDMI 1.4a signals (720p, 1080i,
1080p) with 3D information frame
For example, if the signal is input from the projector's S-Video input socket, and its signal
type (resolution) is 480i, then the default 3D Sync setting of the projector is Off, and the
options you can choose for the 3D Sync setting are Off and Frame Sequential.
When the 3D Sync function is on:
• The brightness level of the projected image will decrease.
• The Color Mode cannot be adjusted.
• The Keystone can only be adjusted within limited degrees.
• The Zoom can only magnify the pictures to limited sizes.
If you discover the inversion of the 3D image depth, set the 3D Sync Invert function to "Invert"
to correct the problem.

Using the projector in standby mode

Some of the projector functions are available in standby mode (plugged in but not turned
on). To use these functions, be sure you have turned on the corresponding menus under
SYSTEM SETTING: BASIC > Standby Settings, and the cable connections are correctly
made. For the connection methods, see the Connection chapter.
Power Saving
Less than 0.5W power consumption when Power Saving mode is turned on.
Active VGA Out
Selecting On outputs a VGA signal when the COMPUTER IN 1 and COMPUTER OUT
sockets are correctly connected to devices. The projector outputs the signal received only
from COMPUTER IN 1.
Default setting 3D Sync options available
Frame Sequential Off, Frame Sequential
Off, Frame Sequential,
Off Frame Packing, Top-
Bottom, Side-by-Side
Off Off, Frame Sequential
120Hz:Off, Frame
Sequential
120Hz: Off
60Hz: Off, Frame
60Hz: Off
Sequential, Frame Packing,
Top-Bottom, Side-by-Side
Auto, Off, Frame
Auto Sequential, Frame Packing,
Top-Bottom, Side-by-Side
38