Table of Contents
Advertisement
Entering the BIOS Setup
Windows
8 boot time is quite fast, so we developed three ways for you to quickly access
®
the BIOS (Basic Input and Output System), which stores system hardware settings that are
needed for system startup in your All-in-one PC.
To quickly access the BIOS, do any of the following:
•
When your All-in-one PC is off, press the power button for at least four (4) seconds to
access the BIOS directly.
•
Press the power button for at least four (4) seconds to shut down your All-in-one PC,
then press the power button again to turn your All-in-one PC back on, and press <F2>
during POST.
•
When your All-in-one PC is off, disconnect the power cord from your All-in-one PC's
power connector. Reconnect the power cord and press the power button to turn on your
All-in-one PC. Press <F2> during POST.
NOTE: POST (Power-On Self Test) is a series of software controlled diagnostic tests that run when
you turn on your All-in-one PC.
WARNING! Inappropriate BIOS settings may result to instability or boot failure. We strongly
recommend that you change the BIOS settings only with the help of a trained service personnel.
Advertisement
Table of Contents
