Easycoder Px4/6I Printers - Intermec EasyCoder PM4i Installation Instructions Manual

EasyCoder PX4i and PX6i Printers
• Switch off the power and disconnect the power cord.
• Disconnect all communication cables.
• Open the right-hand door.
• Remove the eight #T10 Torx screws that hold the left-hand cover.
• Put the cover aside on a soft cloth or similar to avoid scratches.
Th e electronics compartment contains high voltage compo-
nents and wires. Do not open the electronics compartment
before the printer is safely disconnected from any AC
supply.
• Remove the one or two cover plates depending on how many interface
boards you are going to install. Each plate is held by two #T10 Torx
screws. Always start installation at the innermost position.
Inner cover plate
Outer cover plate
Serial/Industrial Interface Kit Installation Instructions
Chapter 2 — Physical Installation
15