Step 5: Installing The Tv On The Wall - Sony KDL-32ML130 Instructions Manual

Step 5:
Installing the TV on the
wall
If you intend to install a TV that is not specified on page 2, be
sure to refer to its operating instructions, or the supplied
leaflet.
WARNING
Be sure to complete the installation before connecting the
AC power cord to the wall outlet. If you allow the AC
power cord to be pinched under or between pieces of
equipment, this may result in a short circuit or an electric
shock.
Be careful not to stumble over the AC power cord or the
TV, as you may hurt yourself.
1
Connect the AC power cord and
the connecting cable(s) supplied
with the TV to the TV.
Connect the AC power cord and the connecting
cable(s) to the connectors on the rear of the TV. For
details on connecting the AC power cord and the
connecting cable(s), refer to the instruction manual of
the TV.
Notes
• You cannot connect the cables to the TV after installing it
on the Base Bracket.
• Subcontract the cable routing in the wall to a licensed
contractor.
2
Install the TV onto the Base
Bracket.
1 Referring to the Screw and Hook locations
diagram/table on page 13, determine the holes of
the Base Bracket for latching the upper hooks of the
Mounting Hook.
2 Hold the TV securely with both hands, and gently
align it on the wall.
WARNING
Be sure that two or more persons hold the TV when
carrying it.
10
(GB)
1
Mounting Hook
3
Firmly secure the TV and the
Base Bracket using the two
supplied screws (+BVST4 × 12).
Note
When using an electric screwdriver, set the torque setting to
approximately 1.5 N·m {15 kgf·cm}.
WARNING
Be sure to tighten both left and right securing
screws firmly. If you fail to do so, the TV may fall
when it is pushed upward and cause injury.
2
Base Bracket
Screw
(+BVST4 × 12)