Advanced Settings - Edimax Wireless VPN Broadband Router User Manual

Clone MAC
MAC address
Set Security
Click <Apply> at the bottom of the screen to save the above
configurations. You can now configure other advance sections or start
using the router (with the advance settings in place)

2.4.2 Advanced Settings

You can set advanced wireless LAN parameters of this router. The
parameters include Authentication Type, Fragment Threshold, RTS
Threshold, Beacon Interval, Preamble Type ...... You should not change
these parameters unless you know what effect the changes will have on
this router.
Click the "Clone MAC" button will copy the MAC
address of your PC, that you are using to
configure the AP, to the WLAN MAC.
If you want to bridge more than one networks
together with wireless LAN, you have to set this
access point to "AP Bridge-Point to Point mode",
"AP Bridge-Point to Multi-Point mode" or "AP
Bridge-WDS mode". You have to enter the
MAC addresses of other access points that join
the bridging work.
Click the "Set Security" button, then a "WDS
Security Settings" will pop up. You can set the
security parameters used to bridge access
points together here when your AP is in AP
Bridge modes. You can refer to section 4.3
"Security Settings" for how to set the
parameters.
40