How To Put The Detergent In And Add The Fabric Softener; How To Clean The Filter; Cleaning The Filter Net - Samsung WA1065D1 User Manual

HOW TO PUT THE DETERGENT IN AND ADD THE FABRIC SOFTENER

1.Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim over the box.
•
When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
•
Do not use detergent, bleach or starch into
the Softener Inlet.
•
Using too much softener may produce
unsatisfactory results.
CAUTION : If softener is stored over the above base line, it may flow down at any time.
For South Africa, Please use the regular Hi-Foam Washing powder.

HOW TO CLEAN THE FILTER

1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and rotate
the filter clockwise
until it locks in position.

CLEANING THE FILTER NET

1. Push the upper part
of the filter and pull in.
1. Push up and
pull out the filter net.
Detergent Device
Put the detergent
in proportion to
water level
Softener Device
Softener
baseline
Clean the filter net often to keep the washer clean.
2. Open the cover as
shown in the figure.
2. Remove the collected
lint from the filter net.
•
Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
•
Do not leave the softener
into the Softener
Dispenser for a long time.
Because softner
became stiff.
(pump drained washer)
1.Place a rag under washer filter not to wet the floor.
2.Turn the filter-cap to the left.
3.Take the filter out and
remove dirts.
4. Reassemble in
reverse order.
3. Clean the filter.
3. Clean the filter.
9
Softener Device
4. Close the cover and insert the
lower part of the filter in the
basket first and then push the
filter with "click" sound .
4. Pull down the filter net.