Inserting Remote Control Batteries; Connecting The Loudspeakers - Samsung MAX-VJ730 Instruction Manual

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and never mix
alkaline and manganese batteries.
1
Place your thumb on the position marked
cover (rear of the remote control) and push the cover
in the direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to respect the
polarities:
+ on the battery against + in the battery compartment
– on the battery against – in the battery compartment
3
Replace the cover by sliding it back until it clicks into position.
If you will not be using the remote control for a long time, remove the
batteries to prevent corrosion.

Connecting the Loudspeakers

Connect the connecting jacks (4) to the back of mini-compact system.
Make sure the colors of the speaker terminals match the colors of the connecting jacks.
Make sure the polarities (+and -) are correct.
Directions in Installing Speaker
Installation in a place near heating apparatus, under direct lay of light or with high humidity may cause performance degradation of the speaker.
Do not install on the wall or on a high place of pole or other unstable place to prevent any safety accident caused by falling of the speaker.
Do not take the speaker apart from TV or computer monitor.
The speaker near the TV or computer monitor may influence the quality of the screen display.
on the battery compartment
GB
7