How To Connect To Anynet; Connecting The Fm And Am Antennas - Samsung HT-DS660 Instruction Manual

How to Connect to Anynet

Using the Anynet function, the DVD Home Theater System can be conveniently controlled from
your Samsung TV. By connecting the Anynet output terminal on the DVD Home Theater
System to the input terminal of any Samsung Anynet-enabled device, both can be controlled
from your TV. For detailed operation instructions and connection diagram, refer to the user's
manual of your Anynet-enabled TV.
What is Anynet?
•
The Anynet function allows you to use your TV's remote control and menu to control all AV devices.
• However, this function is available only with Samsung Anynet-enabled models.
VIDEO IN
ANYNET
TERMINAL
1
Connect the Anynet input terminal on the back of this unit to your Samsung TV's Anynet
output terminal.
2
Connect the Anynet Out Terminal on the back of this unit to the Anynet input of Samsung
external AV devices.
3
Refer to the user's manual of your Anynet-enabled TV and activate the Anynet function.
This function is available only with Anynet-enabled TVs.
*
Caution
•
If the Anynet input and output terminals are reversed, communication with the TV will fail and
you will not be able to use the Anynet function.
19
Other AV devices
Samsung DVD player
Samsung VCR
Samsung Set-Top Box
Use this to connect Anynet-enabled
AV devices when necessary.

Connecting the FM and AM Antennas

If AM reception is poor, connect an
outdoor AM antenna(not supplied).
FM Antenna (supplied)
FM antenna connection
1. Connect the FM antenna supplied to the FM 75
COAXIAL terminal as a temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75 coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
Cooling Fan
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
•
Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
1 2 3
AM Loop Antenna
(supplied)
A
N
T
E
N
N
A
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
AM antenna connection
1. Connect the AM loop antenna supplied
to the AM and terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
20