Table of Contents
Advertisement
Available languages
Available languages
TROUBLESHOOTING
Problem
Possible cause
No display LED on
Power cord
the front panel;
not plugged in correctly
No power supply
No pictures on the screen
Receiver in Standby mode;
SCART not connected tightly
to video output of television;
incorrect channel or video
output selected on television
No sound
Audio cord connected
incorrectly;
Loudness level = 0;
Muting active
Remote Control does not
incorrect operation;
operate directly
Batteries dead or inserted
incorrectly
Poor picture quality
Signal strength to low
signal strength in
On-Screen Error Message
cable not connected or not
"Searching for signal"
tight
On-Screen Error Message
Channel lists not installed
"Channel data does not
exist."
On-Screen Error Messages:
Smartcard:
"Please check the
- not plugged in correctly;
Smartcard";
- not plugged in.
"Please insert the
Smartcard".
DISPOSAL
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed of with
household refuse. Please obtain appropriate information about the regulations in your community,
and dispose of all refuse in accordance with regulations at the separate locations provided.
GB-26
Solution of the problem
Power cord plug in correctly
Set receiver to "On";
Check connection and correct;
Check channel and video output and
correct (TV instruction manual)
Check connection and correct;
Increase loudness on television set;
Press the MUTE key
Point remote control
towards the Receiver.
Replace batteries or insert correctly
Check all wire connections. Check the
the "Scanning" menu, correct
alignment of your antenna
Check connection and correct
Scan channels. Please go to Installation
menu
(depend on model)
Check the Smartcard.
"Insert the Smartcard."
D
I
G
I
T
A
L
C
TECHNICAL SPECIFICATIONS
Power supply
Type :
Input voltage :
Fuse rating :
Tuner & Demodulator
Input Frequency :
DEMODULATION :
SYMBOL RATE :
Constellation :
CABLE OUT :
Video decoder
System decoding :
Profile and level :
Data rate :
Video formats :
Picture resolution :
Audio Decoder
System decoding :
Audio mode :
Sampling frequency :
BASE-BAND AUDIO/VIDEO OUTPUT
VIDEO
Interface :
Impedance :
Output level :
AUDIO Interface :
Impedance :
Output level :
S/PDIF (Digital Audio Output)
MEMORY
Flash
SDRAM
PHISICAL SPECIFICATION
Size (W x D x H)
Weight (Net)
A
B
L
E
R
E
C
E
I
V
E
R
SMPS
AC 100-240V~, 50/60 Hz
250 V/T1.6AH
VHF,UHF BAND(50~870 MHz)
QAM DVB-C
MAX 7 Msps
16, 32, 64, 128, 256 QAM
LOOPOUT FOR ANALOG RECEIVER
MPEG 2 ISO/TEC 13818
(Transport Stream)
MPEG 2 MP@ML (4:2:2)
1 ~ 15 Mb/s
4:3 (normal) & 16:9 (widescreen)
720(H) x 576(V) x 50 fields/sec
MPEG 1 ISO/TEC 11172~3 layer I & II
MONO, DUAL, STEREO, JOINT STEREO
32, 44.1, 48 kHz
PAL
2 SCART (AV1, AV2)
75 Ω
1Vp-p
SCART
600 balance
2.0Vp-p max (controllable)
2MB
8MB
233 x 176 x 38 mm
0.95Kg
GB-27
Advertisement
Chapters
Table of Contents
