3.0
Electrical System Installation
3.1
Nomenclature Descriptions:
ATO... the fuse configuration is ATO. When replacing this fuse, ask for an ATO fuse.
"a"... Amperage.
Important: The wiring hardware and instructions included with this kit are intended for 12-volt electrical systems only.
Before attempting to wire your Edelbrock Performer nitrous oxide system, examine and follow the wiring diagram on
the following page. Please call the Edelbrock Technical department with any questions concerning electrical wiring.
When working with electrical systems in your vehicle, it is a good idea to have a service manual that features your vehicle.
It is also good practice to have a book that specializes on the specialized techniques required when working with
vehicular electrical systems.
©2004 Edelbrock Corporation
Brochure No. 63-0190 - DC/mc
Nitrous Electrical Components Bill of Materials (BOM)
em #
Quantity
It
1
1 ea.
2
1 ea.
3
2 ea.
4
2 ea.
5
1 ea.
6
1 ea.
7
1 ea.
8
6 ea.
9
2 ea.
10
2 ea.
11
3 ea.
12
5 ea.
13
1 ea.
14
1 ea.
15
1 ea.
16
1 ea.
17
2 ea.
Description
Activation microswitch
Activation microswitch bracket (not shown)
Activation microswitch mounting nut
Activation microswitch mounting screw
2 Stage 30 amp relay
Wire harness with integral relay/fuse holders
Red lighted toggle switch
18/22g female spade connector, Nylon insulated
14/16g female spade connector, Nylon insulated
14-16g male spade connector, Nylon insulated
16/18, splice connector
14/16g 3/8" ring terminal, Nylon insulated
Male blade fuse tap
14/16g male spade connector, Nylon insulated
Nitrous 2nd stage push button
20 amp ATO blade fuse
18/22g female spade connector, Nylon insulated
Page 16 of 28
Rev. 03/04
Catalog #70003 & #70004