Table of Contents
Advertisement
Lens Connector (19)
• EPin configuration
<Front View>
Pan/Tilt Control Connector (20)
• Pin configuration
<Front View>
Note:
Be sure to follow the conditions indicated below.
1. Functions are active at the Low control voltage.
2. Open Collector Output (Withstand voltage of
Transistor is maximum 30 V.)
3. Current is maximum 20 mA.
Audio System Operation with the optional Remote Control Unit
The audio output to the Remote Control Unit WV-RC700A is available in the VP Multiplex operation.
1. Connect a coaxial cable between the Remote Control Unit WV-RC700A and Power Separator WV-PS700.
2. Connect the Multiplex Output Cable on WV-PS700 to the Multiplex Signal Input Connector (15) on this adaptor.
3. Set the Audio Level Selection Switch (11) to the –20 dB position.
4. Remove four screws from the side cover of this adaptor.
5. Set the Switch 1 on the Audio board inside this adaptor to the AUDIO position.
6. Set the Switch 2 on the MOD board inside the Remote Control Unit WV-RC700A to the AUDIO position.
Notes:
1. At this time, the intercommunication system cannot function.
2. The Switch 1 on the Audio board is preset to the INCOM position at the factory.
1
Not used
2
Not used
3
GND
4
Not used
5
Not used
6
+12V IN
7
+5V IN
8
FOCUS CONT
9
ZOOM CONT
10
Not used
11
+7.5V IN
12
+2.5V IN
1
GND
2
COM (0V)
3
Not used
4
LEFT
5
RIGTH
6
UP
7
DOWN
8
DEFROSTER
9
WIPER
10
Not used
Remove four Screws.
• Control Voltage (each voltage is ±0.5V.) for the
lens.
NEAR
FAR
WIDE
TELE
Optional Pan/Tilt Control Cable
WV-CA10U25
-5-
Speed
Low
High
4.0V
2.5V
6.0V
7.5V
4.0V
2.5V
6.0V
7.5V
Red
Brown
Glay
Purple
Blie
Green
Yellow
White
SW1
(Set this switch to
AUDIO position.)
INCOM
AUDIO
Advertisement
Table of Contents
