I Hear A Hum When I Select The Phono Input; Video; I Can't See The Program I'm Playing On The Tv There Wasn't Any Video Output To My Vcr When I Recorded; Powertouch - Kenwood KRF-X9992D User Manual

Video/PowerTouch

I hear a hum when I select the PHONO input

Check that:
• The audio cables are connected securely to the Phono jack
set. See Chapter One of the Connections and Setup Guide.
• The turntable is grounded on the receiver. See Chapter One
of the Connections and Setup Guide.

Video

I can't see the program I'm playing on the TV
There wasn't any video output to my VCR when I recorded
• Check that the video source and TV are connected via the
same type of connectors. S-Video input signals cannot be
transmitted via composite (standard) connections and vice
versa.
• Check that the correct video input on the TV is selected.
• Check that the video software you record does not have copy
guard protection.

PowerTouch

I don't see icons for all my devices

You must identify devices for PowerTouch control for them to
appear in the icon bar on PowerTouch. See Chapter Two of the
Connections and Setup Guide.

When I select a device icon, I don't see any commands

• When you start PowerTouch for the very first time, all the
possible icons appear. If you select any of them, there will be
no commands in the command area. You must set up
PowerTouch before you can begin controlling devices. See
Chapter Two of the Connections and Setup Guide.
76 Audio-Video Receiver KRF-X9992D