System Control Cord; System Connections - Kenwood DP-R6090 Instruction Manual

System connections

Caution:
4
Do not plug in the power lead until all connections are com-
pleted.
Make connections as shown below.
When connecting the related system components, refer also to the
instruction manuals of the related components.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer
dimensions including projections) equal to, or greater than, shown below.
Left and right panels: 10 cm
SL 16/XS8 switch
AC110-220V AC220-240V
To AC outlet
Audio cord
1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
Notes Notes
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Rear panel: 10 cm
75 coaxial cable with RCA PIN.
(Commercially-available)
Commercially-available
optical fiber cable
6
LINE OUTPUT
SYSTEM CONTROL DIGITAL OUTPUT
ƒ
VARIABLE COAXIAL OPTICAL
L
SL16 XS 8
R
TEXT
Remove the protection cap when using
the DIGITAL OUTPUT (OPTICAL) jack.
SYSTEM
CONTROL

System control cord

CD
L
R
Malfunction of microcomputer
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microcomputer referring to "In case of difficulty".
Digital component (MD, DAT, etc.)
(COAXIAL)
DIGITAL INPUT
(OPTICAL)
Commercially-available
optical fiber cable
DIGITAL
INPUT
OPTICAL
Digital amplifier
(or ordinary amplifier,
receiver, etc.)
DP-R7090/R6090 (En)
£
To wall AC outlet