Connecting Wires To Terminals - Kenwood KRC-689 Instruction Manual

Connecting Wires to Terminals

2WARNING
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source
running through the fuse box.
2CAUTION
When only two speakers are being connected to the
system, connect the connectors either to both the
front output terminals or to both the rear output
terminals (do not mix front and rear). For example, if
you connect the + connector of the left speaker to a
front output terminal, do not connect the - connector
to a rear output terminal.
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect
to its power control terminal.
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
to the power terminal for the booster amplifier of the
film-type antenna.
Connect either to the power control terminal when
using the optional power amplifier, or to the antenna
control terminal in the vehicle.
To car light control switch
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
Car fuse
box
(Main fuse)
Battery
Rear left output (White)
Rear right output (Red)
FM/AM antenna input
Power control wire (Blue/White)
P.CONT
(KRC-789/689 only)
ANT. Motor antenna control wire (Blue)
CONT.
(KRC-789/689 only)
P.CONT
Power control/Motor antenna control wire
ANT.
CONT.
(Blue/White) (KRC-781R only)
Dimmer control wire (Orange / White)
ILLUMI
EXT.CONT. External amplifier control wire
(Pink / Black)
TEL MUTE
TEL mute wire (Brown) (KRC-781R only)
Ignition key
switch
ACC
Car fuse box
Ground wire (Black) - (To car chassis)
+ –
Front left output (White)
Front right output (Red)
Wiring harness
(Accessory1)
Ignition wire (Red)
Battery wire (Yellow)
— 36 —
To KENWOOD disc changer/
DAB control input/
KPA-SD100/KPA-HD100/KPA-
SS100
NOTE
To connect these leads, refer to the
relevant instruction manuals.
Fuse (10A)
White/Black
To front left
speaker
FRONT • L +
White
Gray/Black
To front right
speaker
+
FRONT • R
Gray
Green/Black
To rear left
speaker
+
REAR • L
Green
Purple/Black
To rear right
speaker
REAR • R +
Purple