Edelbrock 5776 Installation Instructions

Please study these instructions carefully before installing your new Edelbrock Exhaust System. If you have any questions, please
contact our Technical Hotline at: 1-800-416-8628 , 7am - 5pm, Monday-Friday, Pacific Standard Time or e-mail us at
Edelbrock@Edelbrock.com.
Suggested Tools for Installation:
❑ 3/8" ratchet and SAE & metric sockets
❑ Hacksaw, sawzall, chopsaw
Proper installation is the responsibility of the installer. Improper installation will void warranty and may result in
DISASSEMBLY
1. Lift and support vehicle on correct load rated jackstand on
stable surface.
2. Unbolt I-pipe from just in front of muffler.
3. Cutting overaxle pipe at rear of muffler will make removing
muffler, overaxle, and I-pipe assembly easier, remove
muffler, I-pipe, and overaxle at this time.
ASSEMBLY
1. Bolt the I-pipe #25-3314 onto the flange at the rear of the
particulate filter using supplied gasket.
2. Install muffler with inlet facing forward using a 4" band
clamp #23-1820 from the installation kit, snug at this time.
Note that the inlet end of the muffler has the number
stamped on the end cap (#25-5578).
3. Install the overaxle assembly #25-3315 placing the hanger
into the rubber isolator and slip into muffler using a 4" band
clamp, snug at this time.
4. Install overaxle extension pipe #25-3316 placing the hanger
into the rubber isolator and connecting the pipe to the
overaxle pipe using a 4" band clamp, snug at this time.
5. Install tailpipe #25-2392 using a 4" band clamp, snug at this
time. Welding the tailpipe is highly recommended.
©2007 Edelbrock Corporation
Catalog #5776
®
IMPORTANT NOTE:
poor performance and engine or vehicle damage.
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line: (800) 416-8628
Office: (310) 781-2222
E-Mail: Edelbrock@Edelbrock.com
EDELBROCK DIESEL EXHAUST SYSTEM
/
for 2007 1 , 2008 Chevrolet, GMC 6.6L Duramax
2
Crew Cab, Long Bed, & Short Bed
❑ Jack and jackstands
❑ Liquid penetrant and rubber lubricant
6. Starting at the front of the vehicle to rear, align and
tighten all clamps and hanger clamp assemblies. Position
system for clearance around surrounding hoses, lines,
cables, spare tire, and frame members for best clearance.
7. Make one final inspection for clearance around brake,
fuel lines, and wiring.
Exhaust gas contains carbon monoxide, a deadly
invisible gas. Correct any leaks before driving!
Qty. Part #
❑ 1
25-3314
❑ 1
25-3316
❑ 1
25-3315
❑ 1
25-3292
❑ 1
25-5578
❑ 1
22-5776
Catalog #5776

INSTALLATION INSTRUCTIONS

WARNING!!!
KIT CONTENTS
Description
I-pipe assembly
Overaxle pipe extension
Overaxle pipe assembly
Tail pipe assembly
Muffler assembly
Installation kit hardware
Brochure No. 63-5776
Rev. 11/07 - AJ/mc