Edelbrock 5708 Installation Instructions

Please study these instructions carefully before installing your new Edelbrock Cat-Back Exhaust System. If you have any
questions, please contact our Technical Hotline at: 1-800-416-8628 , 7am - 5pm, Monday-Friday, Pacific Standard
Time or e-mail us at Edelbrock@Edelbrock.com.
Suggested Tools for Installation:
❑ 3/8" ratchet set and metric sockets
❑ Jack and jackstands
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
NOTE BEFORE YOU START:
This Edelbrock cat-back system comes with three different I-pipes. This is because some Tundras (between 2000-2006)
use three catalytic converters. Others use 2 catalytic converters and a resonator. If your vehicle came from the factory
with 3 catalytic converters, you will use I-pipe #25-3269 behind the third catalytic converter. If your vehicle came from
the factory with 2 catalytic converters and a resonator, you have the choice of either retaining the resonator for a more
melow exhaust tone, or eliminating the resonator which will give you a more aggressive exhaust tone. See appropriate
steps below.
IMPORTANT NOTES:
• Support your vehicle with proper jackstands or ramps rated for the total vehicle weight. Place stands so that the rear
axle is allowed to hang free for easy system removal.
• These cat-back systems are engineered to fit stock catalytic converters or equivalent replacements. If you original
system has been modified, Edelbrock will not warranty fit or performance.
DISASSEMBLY
Vehicles Equipped with 3 O.E. Catalytic Converters:
1. Remove the V-band clamp behind the rear most
catalytic converter.
2. Remove the stock hanger bars from their isolators
behind the third catalytic converter and remove the
O.E. exhaust system from the vehicle.
3. Install I-pipe #25-3269 behind the rear most
catalytic converter (See Fig. 1).
Vehicles Equipped with 2 O.E. Catalytic Converters
& A Resonator:
1. If you are retaining your O.E., resonator, cut the
factory I-pipe 10" from the back of the O.E.
resonator. If you want to eliminate the O.E.
resonator, cut the factory I-pipe right where it enters
the O.E. resonator.
©2006 Edelbrock Corporation
Catalog #5708
For 2000-2006 Toyota Tundra 3.7L & 4.7L V8, 2WD & 4WD
IMPORTANT NOTE:
result in poor performance and engine or vehicle damage.
INSTALLATION INSTRUCTIONS
EDELBROCK CAT-BACK EXHAUST SYSTEM
❑ 9/16" and 15mm wrench
❑ Liquid penetrant and rubber lubricant
2. Remove the stock hanger bars from their isolators
behind the resonator and remove the O.E. exhaust
system from the vehicle.
Page 1 of 2
Catalog #5708
INSTALLATION INSTRUCTIONS
❑ Hacksaw
Brochure No. 63-5708
Rev. 10/06 - DA/mc
Fig. 1