Edelbrock 5282 Installation Instructions

Please study these instructions carefully before installing your new adjustable torque arm. If you have any questions,
please contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific
Standard Time or e-mail us at edelbrock@edelbrock.com. Please fill out and mail your warranty card.
IMPORTANT NOTE: Proper installation is the responsibility of the installer.
Improper installation may result in poor performance and engine or vehicle damage.
Application: This torque arm is designed to fit 1984-2002 Camaro and Firebird with 1) US built, GM corporate 10 bolt
rear ends that have 7 ½" or 7 5/8" ring gear and, 2) with front torque arm locator lips facing away from driveshaft
(See Fig. 1).
PREPARATION CHECKLIST, TOOLS, AND EQUIPMENT REQUIRED:
K 4 Post drive on vehicle lift recommended, or
K Floor jack and 4 properly rated jackstands
K 13mm, 15mm, 21mm, & 15/16" sockets and wrenches
K Torque wrench
K Magnetic angle finder gauge
©2005 Edelbrock Corporation
Brochure No. 63-0482
for 1984-2002 Camaro / Firebird
Fig. 1
K Drill with &/32 drill bit or grinder (to remove
rivets)
K 1-1/8" crows foot wrench (to properly
re-torque adjuster sleeve jam nuts)
K Thread locking compound
Page 1 of 3
ADJUSTABLE TORQUE ARM
Catalog #5282
INSTALLATION INSTRUCTIONS
Rev. 12/05 - DA/mc
Catalog #5282