Update Utilities - Dell PowerEdge C5220 Hardware Owner's Manual

Installation Problems
Perform the following checks if you are troubleshooting an installation
problem:
• Check all cable and power connections (including all rack cable
connections).
• Unplug the power cord, and wait one minute. Then reconnect the power
cord and try again.
• If the network is reporting an error, see if there is enough memory installed
and disk space available.
• Remove all peripherals, one at a time, and try to turn on the system. If
after removing an option the system works, you may find that it is a
problem with the option or a configuration problem between the
peripheral and the system. Contact the option vendor for assistance.
• If the system does not turn on, check the LED display. If the power LED is
not on, you may not be receiving AC power. Check the AC power cord to
make sure that it is securely connected.
Troubleshooting External Connections
Loose or improperly connected cables are the most likely source of problems
for the system, monitor, and other peripherals (such as a printer, keyboard,
mouse, or other external device). Ensure that all external cables are securely
attached to the external connectors on your system. See the system's
hardware owner's manual for the back panel connectors on your system.

Update Utilities

This chapter provides information about the update utilities.
BMC Firmware Update
The BMC (Baseboard Management Controller) firmware can be updated
using various ways, including of remotely or locally, and can be achieved by
IPMI command or by utilities. The update should be taken only if necessary.
Troubleshooting
83