E-Mail Setting - Mitsubishi Electric XL7100U User Manual

8. ProjectorView

8.6.2. E-mail setting

(1) Click [SETUP] button in the ProjectorView main window (ALERT E-MAIL).
• Alert E-mail Setup window is displayed.
<Note>
• Be sure to enter data within five minutes after the Alert E-mail Setup window is displayed. Click OK to save
changes. The connection will turn off in five minutes after the window is displayed so you need to go back
to the main window (ALERT E-MAIL) to access the Alert E-mail Setup window.
(2) Set each item referring to the explanation described below.
The following table explains each item.
Regarding the settings, consult your network administrator or check the settings of your E-mail server.
Item
Alert e-mail service
SMTP Server *
1
Port *
2
DNS Server *
3
E-mail address1/2/3 *
4
E-mail from *
4
Authentication settings
Authentication method
User name *
4
Password *
4
SMTP-Auth method
POP server *
1
Port *
2
* Use only alphanumeric characters and marks (- _ . ˜).
1
* For data entry, use alphanumeric characters.
2
* For data entry, use alphanumeric characters and mark (.).
3
* For data entry, use alphanumeric characters and marks (+ - / = * _ ! ? . , : ; # $ % & ( ) | < > [ ] { } " ' @).
4
Description
Turn ON/OFF the sending of an alert E-mail.
Enter the name of the SMTP server that is used for sending an E-mail. (Designate by
URL or IP address.)
Enter the port number of the SMTP server. (Default value: 25)
Enter the name of the DNS server when you designate the SMTP server or POP
server using an URL. (Designate by IP address.) For details, consult your network
administrator.
Enter the destination address of the alert E-mail. (e.g. administrator@xxx.xxx.xxx)
(Up to 64 characters) (Up to 3 addresses can be designated.)
Enter the source address of the alert E-mail. (e.g. PJView@xxx.xxx.xxx)
Configure the following settings when you use the SMTP server having the
authentication function.
Select the authentication method for sending an E-mail.
OFF:
SMTP-Auth:
POP before SMTP: To use this method, enter User name, Password, POP Server
(When you select the SMTP authentication) Enter the user name and password
registered on the SMTP server.
(When you select the POP before SMTP) Enter the user name and password
registered on the POP server.
Select the SMTP authentication method.
Plain: Password is sent to the SMTP server unencrypted.
Login: Password is sent to the SMTP server unencrypted.
CRAM-MD5: Password is sent encrypted.
Enter the POP server name that is used for the POP before SMTP authentication.
(Designate by URL or IP address.)
Enter the port number of the POP server. (Default: 110)
No authentication for sending an E-mail.
To use this method, enter User name, Password, and SMTP-
Auth method.
name, and Port number.
EN-26