Edelbrock 17930 Installation Instructions

• PLEASE study these instructions carefully before installing your new In-Tank Fuel Pump for 1985-1997 Ford Mustang
(Except 1996-1997 Cobra). If you have any questions or problems, do not hesitate to contact our Technical Hotline at:
1-800-416-8628, from 7am-5pm PST, Mon-Fri, or via e-mail at: Edelbrock@Edelbrock.com. Please fill out and mail
your warranty card.
• Note: Proper installation is the responsibility of the customer. Improper or incomplete installation could result in poor
performance, related component damage, potential severe engine damage, vehicle fire, and will void your warranty. If you
do not feel comfortable installing these parts, we recommend having the installation performed by a professional mechanic.
• Description: This in-tank fuel pump replaces the factory pump and has an increased flow of 155 liters/hour (41 gph).
This in-tank upgrade pump is ideal for supporting performance improvements such as a big-bore throttle body, high
performance intake manifold, camshaft, supercharger, direct port nitrous system, etc. They replace your original pump
exactly and include all necessary hardware for an easy installation:
Kit Contents:
Qty.
K 1
K 1
K 1
K 1
K 1
K 1
K 1
K 1
K 1
• Remember: When working on your vehicle, especially when oil or fuel is present, always work in a well -
ventilated area. Keep all sparks, open flames, or other sources of ignition away from the work area. Failure
to do so could result in a fire or explosion causing vehicle or property damage, personal injury, and/or death.
• Before Beginning: This installation can be accomplished using common tools and procedures. However, you should have
a basic knowledge of automotive repair and modification and be familiar with and comfortable with working on your vehicle.
If you do not feel comfortable working on your vehicle, it is recommended to have the installation completed by a
professional mechanic. Using a factory service manual for your vehicle for reference is helpful.
• Note: Steps shown in these instructions are intended as a general guideline only. If you are not an experienced mechanic,
you should have a copy of your service manual on hand. The installation procedure for replacing your factory fuel pump is
covered in full detail in your factory service manual.
©2003 Edelbrock Corporation
Rev. 11/03
For 1985-1997 Ford Mustang (Except for 1996-1997 Cobra)
Description
Fuel Pump
Fuel Pump Filter
Fuel Pump Isolator
Fuel Tank to Pump Bracket O-Ring
Electrical Connector
Section of Pre-Formed Fuel Hose
Hose Clamp
Fuel Line Retaining Clip (1/4")
Fuel Line Retaining Clip (5/16")
Minimum Tools Required:
1. Lift or appropriate jack
2. OSHA-approved jackstands
3. OSHA-approved fuel transfer pump
4. OSHA-approved fuel storage containers
5. Wire stripping and crimping tool
6. Various hand tools
INSTALLATION NOTES
Page 1 of 4
155 Liter/Hr, In Tank Fuel Pump
Catalog # 17930
INSTALLATION INSTRUCTIONS
Catalog #17930
Brochure #63-0220