Rear-Facing Installation; Vehicle Belt - Safety 1st 22-750 Instruction Manual

4358-3410D Alpha 5pt 1/26/06

Rear-Facing Installation

After deciding whether to use your Vehicle Belts or
LATCH, be sure to read the warnings below as they
pertain to both systems.
WARNING:
!
A loose top anchorage (tether) strap can
result in serious injury or death.
A loose LATCH system can result in
serious injury or death.
11:39 AM Page 29
You may need to remove
the base for narrow vehicle
seats or airline use. See
"Removing Base" in Belt-
Positioning Booster
section.
To use the child restraint
rear-facing without base,
make sure recline stand is
folded under seat.
NOTE: Do not use the
top anchorage strap
(tether) in the rear-facing
position.The top
anchorage strap and hook
should be placed under
the child restraint.
When LATCH is not
available, fasten belt hooks
together behind the child
restraint as shown.
26
Rear-Facing Installation with

Vehicle Belt:

1
2
3
27
Place child restraint rear-
facing in the back seat.
With child restraint in the
most reclined position,
make sure level lines on
shoulder belt positioning
guide are level with
ground. Adjust child
restraint if needed.
NOTE: Tuck top
anchorage strap and hook
under the base or child
restraint.
Thread the vehicle lap or
lap/shoulder belt
combination through the
rear-facing belt slot.
Thread UNDER seat pad
between buckle strap and
rear slots and out
opposite side. Buckle
vehicle belt.
Do not place vehicle
belt over child's legs.
continued on next page.